CAN Repeater
ISO 11898-2 CAN repeater with low-speed option
Remark: This product is discontinued and no longer available.
We recommend to use the successor product, CAN-CR100
The CAN Repeater is used for the galvanic isolation of two segments of a CAN network and for creating star or tree topologies. One special feature of the Repeater is that it separates a defective segment from the rest of the network so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again.
Alternative, the Repeater can be equipped with a low-speed bus interface (ISO 11898-3), allowing the operation as high/low-speed converter. Its galvanic isolation isolates both CAN segments from each other as well as from the power supply.
Features and benefits
- Increased system reliability
- Almost no influence on real-time behavior
- Cost savings due to simple wiring
- Signal conversion between High- and Low-Speed CAN
| Technical data | |
| Display | Transmit (2 green LEDs), defective segment (2 red LEDs) |
| CAN bus interface | ISO 11898-2 with CAN choke. Screw terminals. CAN termination resistors are integrated (switchable). |
| Baudrate | Up to 888 kbps |
| Delay | 200 ns (corresponds ~40 m (~120ft.) bus length) |
| Power supply | 9-35 V DC, 1.5 W typ., through terminals |
| Galvanic isolation | 1 kV, 1 sec.; CAN 1, CAN 2 and power supply are galvanic isolated against each other. |
| Temperature range | -20 ºC ... +70 ºC |
| Housing, size | Plastic enclosure, 110 x 75 x 22 mm |
| Contents of delivery |
| - CAN Repeater |
| - Quick Reference Manual |
Part number(s)
1.01.0064.44000
CAN Repeater, 2x CAN with Galvanic Isolation
1.01.0064.46000
CAN Repeater, 1x CAN, 1x CAN Low Speed, all with Galvanic Isolation
